Setra-system Model SRMD Manual de usuario Pagina 1

1.0 GENERAL INFORMATIONThank you for purchasing the Setra Remote Monitoring Display (SRMD). The SRMD is a digital panel meter with a bright 1” LED dis

2.0 INSTALLATION2.1 Rough-In (see Fig 2.)Install the SRMD in a 4 11/16” square electrical box. Run the power and signal wiring into the box. Two wires

3.0 WIRING TO THE DISPLAYSShown in Fig. 3 is a wiring diagram and picture of the back of the mounting plate. Note that each display has a terminal str

4.0 CALIBRATIONPower the display(s). If you have the Setra humidity and temperature sen-sor, then the displays are already calibrated and ready to use

4.2 Zero and Span CalibrationSet the Voltage Source to 0 VDC and Connect the Voltage Source to the +S and COM terminals on the display.Check the field

5.0 INSTALL MOUNTING PLATEAfter adjusting and verifying the depth of the electrical box relative to the finish wall (see, Fig. 2), install the mounting

6.0 INSTALL FACEPLATEThere are 4 pins on the back of the faceplate. Align the pins with the rubber grommets in the mounting plate. Slowly and evenly p

7.0 RETURNING PRODUCTS FOR REPAIRWhen returning a product to Setra Systems, the material should be carefully packaged and shipped prepaid to:Setra Sys