Setra-system Model SRH Manual de usuario descargar pdf (Pagina 6)

4.0 CALIBRATION

All relative humidity products are fully tested and calibrated prior to shipment in

accordance with the National Institute of Standards and Technology (NIST), the

highest quality standard available.

Once installed in the ﬁeld, no calibration of the units is required. Instead, this

product suite features ﬁeld-replaceable sensor modules that allow the end user

to replace the sensors on-site. This eliminates time consuming and costly factory

calibration, while reducing downtime during service intervals. Additionally, the

duct mount probe is easily accessed by taking off the front cover, removing the

sensor board assembly, and replacing the sensor module on the tip of the sensor

board. This further contributes to a more user-friendly, lower cost product line

that is focused on customer needs and ease of use.

4.1 Remove/Install the Sensor Tip

Note: Power Must be removed from the main PCBA prior to replacing the sensor

tip module. Failure to comply could possibly damage the sensor tip module

Wall Mount

Outdoor and Duct Mount

White

Retaining Clip

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Setra-system Model SRH Manual de usuario Pagina 6